MakerWorld
3D Printer Accessories
Vai al Modello
Over-Engineered Y-Splitter
4.6k
Download
577
Likes
2.8k
Makes
UpdatesVersion 2.1 (09/27/23)Added lead-ins to the filament entry cavityChanged PTFE stop ledge angle at filament exit endAdded note about countersinking PTFE that enters the printerUpdated printing profilesAdded additional sources for the release rings so they can be purchased outside of the USVersion 2Added through hole for an M3x20mm mounting screw. Printed with a 0.4mm nozzle at 0.10mm layer heightAdded printable locking clip STL file to eliminate backlash in fitting/PTFE tube when pulled onPrint with single inlet side on the build plate. Add a 10mm brim to stabilize the printVersion 1BackgroundThis allows you to run material from the AMS or external spool without having to disconnect the PTFE tubing.This uses push to connect fittings as you would see in a typical PTFE connector. Release Rings: QTY: 3 of PC4-UM2I do NOT recommend the printed release rings as they are too fragile and do not securely hold the PTFE tube into place. Amazon (https://www.amazon.com/dp/B0B282NZVW?ref=ppx_
Brandon Raineri pubblica anche su
19 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!