P1S Embedded Replaceable Pad Replaceable pad

Easy Fast Useful™️设计 如果你的原装脚垫磨损了，或者需要将P1S摆放在比较狭窄的桌子上，导致四个脚垫不能放在同一个平面上，那这款模型或许帮助可以解决你的问题 你需要自备1cm厚的EVA泡棉，略薄一点的缓冲材料也是可以的 打印好模型后，将泡棉剪成合适的长度，贴在模型的底面，然后将整个模型嵌入打印机的底部塑料框中，此时，脚垫将应该不会轻易脱出，如果使用了1cm厚的泡棉，你会发现原装脚垫被架高了，不能接触地面，这是正常的 未测试P1P，X1等相似机型 Designed by Easy Fast Useful™️ If your original rubber pads are worn out, or if you need to place the P1S on a relatively narrow desk where the four rubber pads can’t sit on the same plane, this model might help solve your problem. You’ll need to prepare 1 cm-thick EVA foam yourself; a slightly thinner cushioning material will also work. After printing the model, cut the foam to the appropriate length, stick it to the bottom of the model, and then insert the entire model into the bottom plastic frame of the printer. After this, the pads won’t come out easily. If you use 1 cm-thick foam, you’ll notice that the original rubber pads are lifted and no longer touch the ground, this is expected. P1P, X1 compatibility untested