Packout Axe holder

UPDATE: 2023-12-04
I changed the way that the top attaches to come in from the side, this increases the friction and will hold the axe and top in under tension.

Ideally when printing, the holder itself is printed on the side so the layers are perpendicular to the stress points. Keeping the old ones available for now but would recommend using the v2 version.

ORIGINAL:
Just started using the Milwaukee Packout system for camping gear and decided to make a simple attachment to hold a small fiskars splitting axe that leverages the bracket that keeps the drawers closed.
Built in Fusion 360, ideal print is on its edge as the layers will be perpendicular to the load. That said I suspect if sitting on the bottom angle so it prints diagonally it will be strong enough. Recommending to use PETG if especially used outdoors