Palette 2 Simplified Upside Down Wall Mount

This is an easier to print version of Crussty's Palette Pouch. It prints in two pieces (4 if doing swing collar) and doesn't take as long.

No support needed.

The Palette 2 sits in the base and the collar goes around the upper portion, right before the device starts slanting (right over the palette logo).

There are two versions of the collar. A solid version and a 'swing out' version. The swing out allows for easier removal of the device to clear jams, etc. It's held together using M3 bolts as pins. Simply remove one of the pins and swing the arm to free the Palette. To mount the swing out version, assemble it and tighten down the bolts. make sure it rests flat against the wall and mark the screw locations. Remove the front swing and screw the side brackets into the wall. Reattach the front swing.

Works with the Palette cover on or off!