Slicer Discord
Pan / tilt timelapse timer – 3D-Druckmodell von Thingiverse Thingiverse

Pan / tilt timelapse timer

1 Downloads
2 Likes
0 Makes
Zum Modell
I added a top and bottom plate to my AlbertHeijn kitchen timer with a 1/4 inch male/female threads.

This timer is almost the same as the Ikea one, only smaller. I used to just put it somewhere and place the camera on it. This works file but is limited in the ways you can place it.

Now I can just quickly screw it onto mu selfie stick tripod, place it where i want and use the ball joint on the stick to adjust position and angle.

CAREFULL WHEN PLACING HORIZONTALLY. The top part of the timer is not screwed on so it can pop off if the camera is too heavy.


https://youtu.be/gGzQCY9eWsE

https://www.ah.nl/producten/product/wi413847/ah-kookwekker-rvs
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen