Panda

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.   The size is 150x200. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.56mm. The Max Depth is 1.8mm and the Actual Depth is 1.8mm   It is possible to print without ACE by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. It is only black&white artwork. If you use a white with a TD lower than 6, it will have less detail! [TD =Transmission Distance is a measure of how much light filament lets through. Low TD = the filament is not transparent, high TD is the opposite ;) ]    Filaments Used: PLA Elegoo+ Black Transmission Distance: 0.3 PLA Elegoo+ White Transmission Distance: 6 This print uses 3 unique filaments Swap Instructions: Start with Black At layer #8 (0.72mm) swap to White for the rest.