Thingiverse
paper cutter
por stephen_w
24
Descargas
76
Likes
0
Makes
I made a paper cutter ,it used for cutting paper and photograph (width ≤150mm) .
installation instruction is shown in the picture.
special tips:
I need a wallpaper blade, and break off two parts with plier (see picture. ) after inserting blade.( Be careful your hand)
This model was printed using PLA. (fill in 10%，using a lower layer hight (0.15/0.2mm)，no support)
installation instruction is shown in the picture.
special tips:
I need a wallpaper blade, and break off two parts with plier (see picture. ) after inserting blade.( Be careful your hand)
This model was printed using PLA. (fill in 10%，using a lower layer hight (0.15/0.2mm)，no support)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
