Thingiverse
Parallettes
von MoulfX
31
Downloads
46
Likes
0
Makes
Hi,
In this restricted-times when gyms are closed, I designed parallettes to keep training at home. Those can be used for push-ups or l-stand abs, or anything that suit your mind.
The part should be printed with the VDLR logo facing upwards. I recommend using PETG, 0.2mm layer height (couldn't do more cause of my support settings), 30% infill and supports. The print lasted 13h.
I recommend sticking rubbers pads on the bottom to keep them from sliding (depends on what type of ground you're training, though).
Sincerely yours,
Nicolas, VDLR Team.
In this restricted-times when gyms are closed, I designed parallettes to keep training at home. Those can be used for push-ups or l-stand abs, or anything that suit your mind.
The part should be printed with the VDLR logo facing upwards. I recommend using PETG, 0.2mm layer height (couldn't do more cause of my support settings), 30% infill and supports. The print lasted 13h.
I recommend sticking rubbers pads on the bottom to keep them from sliding (depends on what type of ground you're training, though).
Sincerely yours,
Nicolas, VDLR Team.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!