Thingiverse
Parametric Case
von Berraud
0
Downloads
1
Likes
0
Makes
Parametric case made in Solidworks. Insert desired meassurements under "Equations".
Let me know if you find errors and I accept suggestions.
Mount holes for stuff inside is not included yet!
STL parameters:
"Wall"=5mm
"Base"=5mm
"Lid"=5mm
"Lid_Border"=2mm
"Hole_s"=2.7mm (small. part where the screw will thread)
"Hole_b"=3mm (big. Lid side)
"Screw_wall_thicc"=3mm (screw support, increase if it cracks)
"Screw_lenght"=20mm
"Size_x"=120mm
"Size_y"=80mm (wrong direction, sorry)
Let me know if you find errors and I accept suggestions.
Mount holes for stuff inside is not included yet!
STL parameters:
"Wall"=5mm
"Base"=5mm
"Lid"=5mm
"Lid_Border"=2mm
"Hole_s"=2.7mm (small. part where the screw will thread)
"Hole_b"=3mm (big. Lid side)
"Screw_wall_thicc"=3mm (screw support, increase if it cracks)
"Screw_lenght"=20mm
"Size_x"=120mm
"Size_y"=80mm (wrong direction, sorry)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
