Thingiverse
Parametric Hypercube Evolution Bed Bracket
door ThatPlayer
76
Downloads
21
Likes
0
Makes
An attempt at making the bed bracket for the hypercube evolution in openSCAD so it can be parametric.
Turns out my heatbed was a different size, so I needed a 12.5mm bracket or so. Since no one had one, I designed one in openSCAD which meant I might as well make it parametric.
Probably works for 10mm+. Added different options for the T-nut screw size as well, but haven't tested it much.
Turns out my heatbed was a different size, so I needed a 12.5mm bracket or so. Since no one had one, I designed one in openSCAD which meant I might as well make it parametric.
Probably works for 10mm+. Added different options for the T-nut screw size as well, but haven't tested it much.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!