Paramotor remote

Remote control for paramotor.
Designed for ESP32 Huzzah which has battery connection and charging circuit
Communicate with base station through ESP-now not NRF
Has larger 128x64 OLED but remote is overall still same size
The hole for the OLED is slightly too big and i will correct this in future version
This requires the OLED to be trimmed (yes not fun)
Has place for DRV2605 haptic controller and buzzer motor
Uses same hall effect system with magnets as original skateboard remote
Uses normal LiPo battery 2000mAh
retains: dead man switch, on off button and two control buttons
Skateboard control has centre position of throttle and up is brake down is accelerate
Paramotor has up as rest position and full movement is used for throttle
Notch for paramotor spring needs to be corrected. Will be done next version
The position of the spring decides which way it operates (see picture)
Software is in development
![controls details][id]
[id]:https://raw.githubusercontent.com/krulk