Part Scraper

This is a bed scraper I designed to help remove parts after printing. It is designed so you can put the edge at the corner of the stuck part, then use a small mallet to tap the end. This technique works very well for removing parts. I was using a scraper designed (I downloaded from here) and it worked great for a month until it finally broke. This design should be much more durable and purpose designed for this use case.

You will need to re-orient this part with the bottom down. For some reason it initially tries tor print on its side. To make this very durable, I printed this with 8 walls and 50% infill. It will print fine at 3 walls and 20%, but will be less durable. No supports or rafts needed.