Thingiverse
PI-KVM Case
by lurch68b
10
Downloads
3
Likes
0
Makes
This is a case I designed for PI KVM setup that has a feature for a DB9/Serial port for routing GPIO out of the case. No hardware is needed, it should snap together.
Updated the front/bezel part as the feature that holds the HDMI-CSI board as it had a weak point.
For stronger snaps and a better finish, it is best to print with the back of the top and bottom parts on the build plate.
07-31-21 Added the latest revision of the Fuson360 files
08-01-21 Added a not DB9/Serial version of the top
This is the HDMI to CSI2 board that I am using https://bit.ly/3lhPbe8
Updated the front/bezel part as the feature that holds the HDMI-CSI board as it had a weak point.
For stronger snaps and a better finish, it is best to print with the back of the top and bottom parts on the build plate.
07-31-21 Added the latest revision of the Fuson360 files
08-01-21 Added a not DB9/Serial version of the top
This is the HDMI to CSI2 board that I am using https://bit.ly/3lhPbe8
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
