Picture frame attached key hooks

A nice way to keep keys and organized near your door: Hang them below your favourite picture frame! 👉 Please rate the print profiles and follow me if you like - It would help tremendously. 👈 Benefits:prints fast, shouldn't need support material (even the overhang, just try it)no additional holes in the wall / sticky tape on the wallpaperfully configurable via the makerworld websites “customizer” here, or via OpenSCAD via these instructions. CustomizingSelect the number of hooks you would like to have, e.g. 5hooks like in the picture. Then measure the needed gap size: Measure the distance from the back of the picture frame to the groove where the metal clips go into to fix your picture in the frame:Select this in the customizer with a little wiggle room, so for a measurement of 8.7mm use 9mm PrintingThen print the STL file without supports (the small tabs print not perfectly, but it still fit to my wooden picture frame easily). Finally, clip the key hooks into the back of your pic