Slicer Discord
Picture hook – 3D printable model from MakerWorld MakerWorld
Decor

Picture hook

by Almitoen · Decor
57 Downloads
24 Likes
33 Makes
Go to Model
Picture hook Boost MeSupport me as my hook supports your pictures :)Description:This small wall hook allows you to easily hang your pictures without using a traditional nail.The system uses a paperclip piece (10–12 mm) instead of a nail.Several hole diameters are provided to fit different paperclip sizes.➡️ Download the Starter Pack to help you choose the correct hole size. How to use:Cut a piece of paperclip about 10–12 mm long.Insert it into the hole of the hook – it should fit with slight resistance.Place the hook against the wall and gently tap the paperclip in with a hammer.Hang your frame or picture. ⚠️ Important:If the paperclip slides in too easily, the hook will not hold properly and the picture may fall.If the resistance is too strong, the part might break.→ Test the fit before final installation to find the right balance. Included accessory:A small tool called “Save Finger” is included. It helps hold the hook in place during installation and prevents injury when using the ha
Category
Decor
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection