Thingiverse
PID Controller Termperature Controller Case
von odeezee
4
Downloads
7
Likes
0
Makes
The lid is a little loose and I haven't adjusted the model yet. I used .4 mm offset all the way around the rim of the chassis but will go with .34 next test.
Plan assembly.
Feed cord and thermocouple into lid
Put conductor on outlet first and mount
Put conductor on SSD and mount with wires roughly where they will end up on the PID
Install PID Bracket
Install PID and screw down conductor
Plan assembly.
Feed cord and thermocouple into lid
Put conductor on outlet first and mount
Put conductor on SSD and mount with wires roughly where they will end up on the PID
Install PID Bracket
Install PID and screw down conductor
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!