Thingiverse
Pineapple Container
von drwilco
58
Downloads
39
Likes
1
Makes
Designed a container for my partner who loves pineapples. The body of the pineapple is designed from scratch, the leaves are copied from The Pineapple right here on Thingiverse.
## Printing
Scaling to 84% makes a container that holds roughly 550ml, perfect for holding tea. Say green lemon pineapple rooibos. I used tree supports in Cura, only to buildplate, should be a minimal ring of supports on around the bottom. The inside is designed to be printed without supports.
## Finishing
Might need slight sanding for the lid to fit flush, depending on tolerances of your printer.
Remember to use food-safe materials if you're putting food (like tea/coffee) in this.
## Printing
Scaling to 84% makes a container that holds roughly 550ml, perfect for holding tea. Say green lemon pineapple rooibos. I used tree supports in Cura, only to buildplate, should be a minimal ring of supports on around the bottom. The inside is designed to be printed without supports.
## Finishing
Might need slight sanding for the lid to fit flush, depending on tolerances of your printer.
Remember to use food-safe materials if you're putting food (like tea/coffee) in this.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
