Thingiverse
Piseeks box
door igng
18
Downloads
16
Likes
0
Makes
Hi, I'm Mr. Piseeks, look at me!
---
This is a Raspberry Pi 3 case, based on the Meeseeks' Box, from "Rick and Morty". It is a 10cm cube, slightly bigger than the RPi. The side panel has the micro-USB, HDMI and jack ports at the bottom, while in the middle there is a hole for the GPIO pins. The rear (or front, it is up to you) has the "Ethernet+4USB" ports.
It's still a WIP, I'm deciding if modify it to make it fit the RPi leaving no room inside, or leave it as a cube (I'll probably make both).
My main idea is to print it, paint it and place a button on top of it, like the true Meeseeks' Box, and use it like a home-assistant (with the Google Kit released for the RPi) with the Mr. Meeseek voice.
---
This is a Raspberry Pi 3 case, based on the Meeseeks' Box, from "Rick and Morty". It is a 10cm cube, slightly bigger than the RPi. The side panel has the micro-USB, HDMI and jack ports at the bottom, while in the middle there is a hole for the GPIO pins. The rear (or front, it is up to you) has the "Ethernet+4USB" ports.
It's still a WIP, I'm deciding if modify it to make it fit the RPi leaving no room inside, or leave it as a cube (I'll probably make both).
My main idea is to print it, paint it and place a button on top of it, like the true Meeseeks' Box, and use it like a home-assistant (with the Google Kit released for the RPi) with the Mr. Meeseek voice.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!