plainolddave Clarinet Stand - Printer-Friendly Version

This is just a quick re-model of plainolddave's clarinet stand. It's very nice, but his was designed to mainly be used with a laser cutter, which has a lot more overall volume going on since you remove material instead of add it.

I just whipped this up in less than 10 minutes over TinkerCad. I duplicated the base but smaller, made it a hole, then centered it in the middle. Added some support struts. Also put a cylidner through the middle to just make sure everything in there is together since I noticed some disconnections. Overall saves a little bit of material and adds a tad of firmness to the top.