Thingiverse
Plotter Conversion for Anycubic Mega-S
door DonTheMaker
5
Downloads
1
Likes
0
Makes
This pen holder is to convert my Anycubic Mega-S 3D printer into a 2D plotter.
From my research, pen holders that allow the pen to float up and down yield the best results. This device uses a small rubber band was used to apply downward pressure on the pen. 1 mm of tension seems to work well.
The clearance for the slider was .1 mm. But that allowed a tiny amount of side to side movement. So I added a piece of Scotch tape on each side which made a near perfect slip fit.
The 3.5 mm holes were tapped for an M4 thread
(7) M4 x 6mm screws are used to assemble the pieces.
From my research, pen holders that allow the pen to float up and down yield the best results. This device uses a small rubber band was used to apply downward pressure on the pen. 1 mm of tension seems to work well.
The clearance for the slider was .1 mm. But that allowed a tiny amount of side to side movement. So I added a piece of Scotch tape on each side which made a near perfect slip fit.
The 3.5 mm holes were tapped for an M4 thread
(7) M4 x 6mm screws are used to assemble the pieces.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!