Thingiverse
Pneumatic reducer
von Steleguen
6
Downloads
5
Likes
0
Makes
Made this to be able to mount the original pneumatic connector from Prusa MMU2S kit instead of the one mounted on the PitStop, because I don't have it and didn't want to wait :D
Feel free to use and share.
Center hole 4.8mm, outter M10.
Be careful when tightening that the small thread will fail before the outer.
Feel free to use and share.
Center hole 4.8mm, outter M10.
Be careful when tightening that the small thread will fail before the outer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
