Slicer Discord
Pony pipe clamp stands – 3D-Druckmodell von MakerWorld MakerWorld
Measure Tools

Pony pipe clamp stands

313 Downloads
138 Likes
207 Makes
Zum Modell
The stands prevent Popy Jorgensen pipe clamps from falling over constantly. They also elevate the clamps slightly. Part A keeps the clamps upright and must be placed on the screw side. Part B is the end support and can be placed anywhere along the pipe near the sliding end. The stands are used with the ¾ inch (20mm) pipe clamp fixture.Printing tipsTake note of print orientation and support in images - prints must lay down flat on the print bed. Supports: paint supports only on bottom of protrusion for Part A and use normal supports (not tree) for smoother result. Part B doesn't need supports. First layer and top surface: 0.36mmInfill: Cubic 15%Printed in PETG, but PLA will also work. Watch out for too much layer cooling to prevent warping.
Kategorie
Measure Tools
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, PETG
Nachbearbeitung
Bemalen, Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

MarickH veröffentlicht auch auf

5 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen