Thingiverse
Pool Caddy
von Bitmasked
158
Downloads
114
Likes
0
Makes
Pool caddy for above ground pool with oval 3x2 tubing. Snaps over rail.
Printing:
Print two brackets. These need to be rotated to fit the bed of a Prusa. Print with 3 perimeters and 30% infill.
Print each half of the shelf. Infill % as desired. Top infill hilbert curve pattern shown in picture.
Print one support piece, this is used to join the halves together.
Assemble with 6mm countersunk screws.
Snaps over pool rail on a corner.
Printing:
Print two brackets. These need to be rotated to fit the bed of a Prusa. Print with 3 perimeters and 30% infill.
Print each half of the shelf. Infill % as desired. Top infill hilbert curve pattern shown in picture.
Print one support piece, this is used to join the halves together.
Assemble with 6mm countersunk screws.
Snaps over pool rail on a corner.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!