Pool Cue Case

This is a pool cue case with a chalk compartment - lined with 1mm felt (pretty cheap stuff to pickup on ebay or amazon). Whole thing cost me about £10 to print in plastic and hardware, and you end up with a unique and rugged little case. The inserts overlap the segment joints so that the inserts provide strength as well as the glued dove tails.

The make in the picture for a cue that splits in half - but it is modular, just stick more segments together.

Hardware:
Paracord to make the handle (cobra knot)
9 off M4x35mm - 3 for the Hinges, 6 for the latches
2 off M4x20mm - for the handle
Felt
Superglue - a lot - to secure the dove tail joints in place
Double sided tape (I used double width) - to secure inserts to the box, and felt to the bottom of the insert.

For the case in the picture (made of 7 segments), print:
12x Bottom Dove
24x Side Dove
1x Cent 1
1x Cent 2
2x End Seg 1
2x End Seg 2
6 x Seg 1
2x Seg Handle
3x Clip
2x End Insert 1
2x End Insert 2
8x Insert

The Dove tails and