Pool table cover support

This is a support for going under a weather cover for my pool table. The idea is to hold the centre of the cover up so that the rain water runs of and dosn't create a big puddle on the top. The top ring and the bottom ring are joined together using a piece of standard 43mm drain pipe. The connectors are then screwed onto the end of 35mm x 25mm rough cut lathes to form the frame.

The picture is of the V1 connectors but the model uploaded is the V2 model that has holes for screwing to the timber supports. I will also be adding a couple of 'short legs' from the central tower to the middle edged of the table to give the cover a little more support down the long edges.