Thingiverse
Pool Umbrella Insert
von SteveCurtis
7
Downloads
5
Likes
0
Makes
This allows you to use a standard 1.5" patio umbrella in Aquastar USxxx umbrella stand with the sleeve installed.
The threads are 1 7/8-12 for the in-ground/in-pool umbrella stand to match the threaded cap and the hole for the umbrella is 38.75mm to accommodate 1 1/2" patio umbrellas with just a a bit of room for easy in-out but very little side to side movement.
The threads are 1 7/8-12 for the in-ground/in-pool umbrella stand to match the threaded cap and the hole for the umbrella is 38.75mm to accommodate 1 1/2" patio umbrellas with just a a bit of room for easy in-out but very little side to side movement.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
