Thingiverse
Pop Up Parade Basic Stand
von GravityOctopus
1
Downloads
2
Likes
0
Makes
This is made to fit a figure from the Pop Up Parade series from GoodSmile Company snugly.
The starting height is 110 mm. To make it shorter, move down the model on the build plate.
There is no interlocking parts to the stand.
Lightning infill at 15% should be more than enough to hold any of the figures.
The starting height is 110 mm. To make it shorter, move down the model on the build plate.
There is no interlocking parts to the stand.
Lightning infill at 15% should be more than enough to hold any of the figures.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
