Thingiverse
Portable Microphone wire holder
por Mirkoengineer
18
Descargas
19
Likes
0
Makes
This is a simple but very useful project. I wnated to protect and organize the cable for my microphone in order to keep it in good shape and to avoid breaking of the cable or to not allow the cable to tied it self up with impossible knot to undo ;-)
It can be used for haedphones as well!!
INSTRUCTIONS:
There will be 2 stl files. One which doesn't require any support material (I really reccomend this for a better result) but you have to glue the two parts together and the other one which is all in one piece but it does require support material.
- 2 PARTS FILE
Once you have printed it sand really well the two meeting faces then take a 3 mm drill bit and insert the two parts with a small gap between them, then apply CA glue on the two meeting faces and clamp thoose together for 2 minutes. Finally take a 3.5 mm drill bit and with a drill enlarged the hole that should eliminate any miss-allignment and the microphone jack shuold fit in it nice and tight. To finish it just use a bi
It can be used for haedphones as well!!
INSTRUCTIONS:
There will be 2 stl files. One which doesn't require any support material (I really reccomend this for a better result) but you have to glue the two parts together and the other one which is all in one piece but it does require support material.
- 2 PARTS FILE
Once you have printed it sand really well the two meeting faces then take a 3 mm drill bit and insert the two parts with a small gap between them, then apply CA glue on the two meeting faces and clamp thoose together for 2 minutes. Finally take a 3.5 mm drill bit and with a drill enlarged the hole that should eliminate any miss-allignment and the microphone jack shuold fit in it nice and tight. To finish it just use a bi
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
