Thingiverse
Pot Protector
von T_Rover
13
Downloads
12
Likes
0
Makes
Does your pet's tail keep knocking into your plant? If so, I have the thing for you!
There are four rings and four sticks that piece together using dovetail joints and mortise and tenon joints respectively. Feel free to mix-and-match stick lengths to get the desired ring height!
I recommend super gluing the joints in place for a more permanent structure. If the joints are too tight because your printer over extrudes corners, shave away a little material with a sharp knife.
There are four rings and four sticks that piece together using dovetail joints and mortise and tenon joints respectively. Feel free to mix-and-match stick lengths to get the desired ring height!
I recommend super gluing the joints in place for a more permanent structure. If the joints are too tight because your printer over extrudes corners, shave away a little material with a sharp knife.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!