Thingiverse
Potentiometer Knobs
door Old-Steve
45
Downloads
28
Likes
0
Makes
My potentiometer knobs
I have 3 knobs.
15mm, 20mm, and 30mm diameters. All are 15mm’s tall.
There is a ¼” round hole (6mm’s X 12mm’s) for the potentiometer shaft with a pilot hole for a set screw. I used a 6-32 drill/tap combo bit to thread the hole.
There is a slot on top of each knob so you can slide in a piece of 1.75 filament as an indicator. I used white, yellow, and green for high contrast and visibility.
I printed these in PETG .2 layer 20% infill
* I added a fourth knob.
30mm diameter and I hollowed it out on the under side so it uses less plastic.
I have 3 knobs.
15mm, 20mm, and 30mm diameters. All are 15mm’s tall.
There is a ¼” round hole (6mm’s X 12mm’s) for the potentiometer shaft with a pilot hole for a set screw. I used a 6-32 drill/tap combo bit to thread the hole.
There is a slot on top of each knob so you can slide in a piece of 1.75 filament as an indicator. I used white, yellow, and green for high contrast and visibility.
I printed these in PETG .2 layer 20% infill
* I added a fourth knob.
30mm diameter and I hollowed it out on the under side so it uses less plastic.
Old-Steve publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
