Thingiverse
PowerWatcher 3 Case
von rwaudio
1
Downloads
0
Likes
0
Makes
This is a simple case for the PowerWatcher 3 along with the RS485 voltage module and current sensor.
Boards are mounted using M3 bolts and washers, self-tapping into the plastic, do not overtighten.
Lids are friction fit, so you may have to over/undersize the lid just slightly for a good fit depending on your printer.
Boards are mounted using M3 bolts and washers, self-tapping into the plastic, do not overtighten.
Lids are friction fit, so you may have to over/undersize the lid just slightly for a good fit depending on your printer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!