Thingiverse
PrepDeck back holder
door Bigstape88
2
Downloads
0
Likes
0
Makes
Update 8.16.21
I split the file so smaller beds could make this thing.
.125 mating dowel on the upper and a .127 sink on the lower should allow for proper fitment with minimal post processing.
Also added a .525 spacing on the book/phone holding pad so an iphone or ipad with a case on it can fit properly. spacing measures out .537 from lip to backing.
I will try and print this on my replicator 2 when I get a minute to get things going again, if you have any input or request for modifications please comment bellow and i'll get to it ASAP
I split the file so smaller beds could make this thing.
.125 mating dowel on the upper and a .127 sink on the lower should allow for proper fitment with minimal post processing.
Also added a .525 spacing on the book/phone holding pad so an iphone or ipad with a case on it can fit properly. spacing measures out .537 from lip to backing.
I will try and print this on my replicator 2 when I get a minute to get things going again, if you have any input or request for modifications please comment bellow and i'll get to it ASAP
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!