Thingiverse
Printable Spool Box
von EEnzyme
5
Downloads
4
Likes
0
Makes
Practically airtight filament spool box, that is completely printable (except for the four bearings).
I've had this design laying around for almost a year now, wanting to write a god desciption and a nice guide. So now I decided to just upload it as it is :-)
It is a tight fit between the bottom and top, and I had to sand it a little bit.
The bearing based spool roll, was inspired by "The Ultimate Spool Holder" https://www.thingiverse.com/thing:2047554
Fusion 360 source link: https://a360.co/2ObRDT8
Materials:
4x 608 bearings
1x Bottom
1x Top
2x Roller (I printed them vertically)
I've had this design laying around for almost a year now, wanting to write a god desciption and a nice guide. So now I decided to just upload it as it is :-)
It is a tight fit between the bottom and top, and I had to sand it a little bit.
The bearing based spool roll, was inspired by "The Ultimate Spool Holder" https://www.thingiverse.com/thing:2047554
Fusion 360 source link: https://a360.co/2ObRDT8
Materials:
4x 608 bearings
1x Bottom
1x Top
2x Roller (I printed them vertically)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
