Thingiverse
Printer Tests
von pritter24
4
Downloads
2
Likes
0
Makes
Here are some basic tests for your printer.
#SpeedTowerTest
GCODE: sliced using cura, 205°C temp, 60°C bed temp, increase print speed by 20% each level
STL: slice with your own settings
#WallTest
Walls are 0.4mm
use "print thin walls" in cura settings, measure wall width after print
#SpeedTowerTest
GCODE: sliced using cura, 205°C temp, 60°C bed temp, increase print speed by 20% each level
STL: slice with your own settings
#WallTest
Walls are 0.4mm
use "print thin walls" in cura settings, measure wall width after print
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
