Thingiverse
Pro Micro Case
von Andy1111
7
Downloads
5
Likes
0
Makes
This slim case is a nice fit for the arduino pro micro.
I created the hole for the micro usb port upside down, but from what I have seen this makes it more stable.
In the design I was using, I needed a case that held the pro micro and a resistor.
The only modification needed for this is that the inner holder may need to be shaved down depending on your print settings.
I created the hole for the micro usb port upside down, but from what I have seen this makes it more stable.
In the design I was using, I needed a case that held the pro micro and a resistor.
The only modification needed for this is that the inner holder may need to be shaved down depending on your print settings.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
