Thingiverse

Project #MicroLongRange

by Dave_C_FPV

1.2k Downloads

989 Likes

4 Makes

Go to Model

__ABOUT__
The basic idea of the Micro Long Range (MicroLR) ist quite simple: Scale down a 7" long range quad until it is sub 250g AUW. While there are many sub 250 micros the clue here is the electronics layout with a 16x16 stack in the center plus 20x20 stack in the back
as well as the dead cat design and 4" inch props for maximum efficiency. This frame configuration allows you to easily fit an impressive amount of feature in your sub 250 setup:
- GPS for speed, location, return home etc.
- No props in you FPV feed
- 4K video recording with a Naked GoPro or Split Type FPV Camera
- And independent buzzer for easier post crash recovery even if the battery is ejected
- 3+ miles of range with a 800mW VTX or a Caddx Vista Unit
- 10+ minutes of flight time on an 850mah 3-4S LiPo and Up to 30min on LiIon

__FRAME SPEC__
- Max. Prop Size: 4 Inch
- Frame weight: 36g
- Front Stack: 16x16 only (20x20 remixes do exist)
- Rear Stack: 20x20 only
- Cam mounts: 19mm Micro
- Motor Mo

Dave c fpv DIY Drone drone fpv FPV drone long range fpv microlongrange microquad miniquad Quadcopter Dave c fpv DIY Drone drone fpv FPV drone long range fpv microlongrange microquad miniquad Quadcopter Dave c fpv DIY Drone drone fpv FPV drone long range fpv microlongrange microquad miniquad Quadcopter

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format