Thingiverse
Projector Step
von ctrusty
142
Downloads
152
Likes
1
Makes
This is a simple set of steps for a projector's front leg.
I was tired of trying to shove folded paper under the front stand to boost it up to get the height I wanted, so I made a set of stairs that allow for a range of different height's.
The height increments are 5mm, 10mm, 15mm, 20mm, and 25mm.
I printed the steps with the lettering on the top face to avoid having to have supports on the letters.
Thanks for downloading!
I was tired of trying to shove folded paper under the front stand to boost it up to get the height I wanted, so I made a set of stairs that allow for a range of different height's.
The height increments are 5mm, 10mm, 15mm, 20mm, and 25mm.
I printed the steps with the lettering on the top face to avoid having to have supports on the letters.
Thanks for downloading!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!