Thingiverse
Protoboard Stand
von colinsk
3
Downloads
1
Likes
0
Makes
I needed to keep a protoboard off my bench because I was running high voltage through it. I printed two of these. To install, squeeze the feet and the jaw will open wide enough for the board. I printed at 20% fill in PLA. Designed for a 3" wide protoboard.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
