Thingiverse
Learning
Zum Modell
protractor
42
Downloads
78
Likes
0
Makes
I made a protractor, It can draw circles 、angles and measuring angle.
special tips:
When it's finished printing,it might be a little tight.
let it takes a few more turns.
This model was printed using PLA. (fill in 10~15%，using a lower layer hight (0.15~0.2mm)，no support)
special tips:
When it's finished printing,it might be a little tight.
let it takes a few more turns.
This model was printed using PLA. (fill in 10~15%，using a lower layer hight (0.15~0.2mm)，no support)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
