Thingiverse
PTFE Plug
von Whifflesauce
10
Downloads
6
Likes
0
Makes
It's a PTFE/Bowden tube plug.
The stem tapers from 2.5mm to about 1mm to fit snugly in the tube. Even if your like me and open the end of your tubes with a hole punch reamer.
This file was not designed to accommodate shrinkage.
PLA shrinkage is about 2%
The stem tapers from 2.5mm to about 1mm to fit snugly in the tube. Even if your like me and open the end of your tubes with a hole punch reamer.
This file was not designed to accommodate shrinkage.
PLA shrinkage is about 2%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
