pulley

Description:
The shaft and pulley are printed as a single piece.
Recommended settings:
• Layer height: 0.2 mm
• Infill: 10–15%
• Recommended filament: PLA or PETG
• Support: Required
• Required hardware: Two M3 × 10 mm screws

If the rotation feels tight, please sand the shaft lightly.
Please note that this part may experience wear over time due to friction.
Also, please don’t worry about the Japanese text shown in the photos.

Assembly Instructions:

①Insert a screw into one of the shaft stoppers.

②Attach this shaft stopper to one end of the shaft.

③Place the pulley and body together so the pulley sits inside the body.

④Insert the shaft through the body and pulley.

⑤Attach the second shaft stopper to the other end of the shaft.

Refer to the photos for each step if needed.