Thingiverse
Pump Diffusers
por GingerBrandon
1
Descargas
3
Likes
0
Makes
I needed a diffusion spout for the little aquarium pump I had as it was blowing my turtle across the aquarium, so I made this.
It works with a 13mm hole or half inch, but I suppose you could scale it up or down for a different pump.
I also needed one for my Beta tank for the bump there with a 16mm hose, so I made a donut shaped one for him
It works with a 13mm hole or half inch, but I suppose you could scale it up or down for a different pump.
I also needed one for my Beta tank for the bump there with a 16mm hose, so I made a donut shaped one for him
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!