Thingiverse
Push button switch
von mnunez
11
Downloads
7
Likes
0
Makes
Push button switch built in PLA.
In addition, you will need a washer (3mm interior diameter) and two staples (22/6).
It can be converted to NC/NO depending on staples position (NO example in the photos).
In addition, you will need a washer (3mm interior diameter) and two staples (22/6).
It can be converted to NC/NO depending on staples position (NO example in the photos).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!