Thingiverse
Pushrod Keepers
door gowen
524
Downloads
374
Likes
2
Makes
While fitting out my recently completed 3DLabPrint Spitfire XVI I found I didn't have any keepers to suit the pushrod 18swg (1.2mm) wire I was using, so I made some. Also the aileron and elevator control horns on the Spitfire are a lot thicker than standard so I made a range of sizes: 2mm for servo horns, 4mm for the Spitfire and 3mm to fill in the gap.
They are designed to be held in place with 1.6mm zip ties.
##### UPDATE 18/08/17
I've added three extra sizes for use with 1mm wire.
##### UPDATE 04/09/17
I've added a set for use with 2.5mm zip ties.
They are designed to be held in place with 1.6mm zip ties.
##### UPDATE 18/08/17
I've added three extra sizes for use with 1mm wire.
##### UPDATE 04/09/17
I've added a set for use with 2.5mm zip ties.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!