Thingiverse
quadcopter
von stephenytr
24
Downloads
29
Likes
0
Makes
this is a project that i designed at school the aim was to design a very clean looking quadcopter
the electronic speed controllers fit under the grills in the arms
the arms the body and the legs are attached with a 6 mm pressfit copper pipe
the battery holder is hot glued onto the body
battery holder holds a 4cell 3000mah battery
the body holds a arducopter controller and has a mounting point for a reciever
printed on an up box 3d printer
the electronic speed controllers fit under the grills in the arms
the arms the body and the legs are attached with a 6 mm pressfit copper pipe
the battery holder is hot glued onto the body
battery holder holds a 4cell 3000mah battery
the body holds a arducopter controller and has a mounting point for a reciever
printed on an up box 3d printer
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!