Slicer Discord
Quick LIght Timer – 3D-Druckmodell von Thingiverse Thingiverse

Quick LIght Timer

von makedave
94 Downloads
100 Likes
0 Makes
Zum Modell
I was headed out for vacation and wanted a timer for the light on the front of my house. So I made one with stuff I had laying around.

It is a very simple servo project with an arduino board to control it. The time program I created will turn on the light as soon as you turn it on wait 4 hours and turn the light off for 20 hours. (These are all very approximate the way I did the programming, as I was not after accuracy.) After a 2 week vacation it was off by about an hour, but hey close enough. :)
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Ca. Druckzeit
4 h
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen