R/C Controller or Robotics Controller

I wanted a controller and made one.

Was printed on a 220mm x 220mm bed. Object is 210mm.
Printed at .20 layer height with .22 first layer for good adhesion on heated bed with .3mm nozzle diameter.

Electronics are:

NRF24L01 with antenna via ebay
arduino pro mini
3.7v lipo at 750mah with connector
Gimbals where from ebay, but you can customize the ones from hobbyking for use
Potentiometers where b10k cut down slightly for trim control
switches are on/off/on
led for power in the middle
safety pull up switch for center power on
Posts for body where aluminum from local hardware store. Can use model ones.

Works very well and nice 2.4ghz TX.

Hope you enjoy.!!!