R2D2 Revised

The original model was pretty neat, but I wanted a little more detail, and I wanted it able to be printed without additional support so I tweaked it up a bit.
It prints really well and can be scaled down in Repitier to a fairly small size - I printed it as a Star Wars Monopoly piece at .2 as well as full size and both look good...

I did run it through Nettfabb Cloud repair once just to make sure the original pieces were clean.



I finally found some affordable wood filament and decided this model needed to be printed in wood. In the course of doing that, I determined I wanted a little more of the missing detail (ports, marks, etc.) so I revised the model. Biggest additions are the antenna toward the back of his head. I also added some support structure to the legs which is NOT original but helps being able to print this smaller and makes it a bit more robust..

The pictures are the wood filament printed at .6 scale. It looks much better in real life than the pictures