Thingiverse
Raspberry camera mounting
door ouaibsky
125
Downloads
67
Likes
1
Makes
A basic remix to set the connector on bottom of the camera holder (taking benefit of Pi camera wide resolution)
+ link: 30mm long and 2mm width
I strongly suggest to print the bed connector with ABS (at least if you get an hot bed)
Otherwise when you start heating the bed at 50-60º the connector is gonna be "flexible".
+ link: 30mm long and 2mm width
I strongly suggest to print the bed connector with ABS (at least if you get an hot bed)
Otherwise when you start heating the bed at 50-60º the connector is gonna be "flexible".
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
