Thingiverse
Raspberry Pi 3 Case-Large
por ExUmbra117
10
Descargas
5
Likes
0
Makes
I have *not* successfully printed this yet.
Few tries, but my filament and printer aren't cooperating.
I was looking for a larger case for the Pi, which could be stood on an end instead of laying, so that I could accommodate a heatsink on the underside and potentially have dual fans w/ airflow slits on the larger faces.
Larger openings for easier access with cable ends, raised supports from case for heatsink and/or fan space, pin/screw closures on edges.
Top half coming soon.
**Feedback welcome and requested!**
**See below regarding the other access holes**
*EDIT*
Top now uploaded. Cut-away section where it would be opposite the larger chip on the "top" side of the board.
Will create cut-away section for airflow on lower section soon.
Few tries, but my filament and printer aren't cooperating.
I was looking for a larger case for the Pi, which could be stood on an end instead of laying, so that I could accommodate a heatsink on the underside and potentially have dual fans w/ airflow slits on the larger faces.
Larger openings for easier access with cable ends, raised supports from case for heatsink and/or fan space, pin/screw closures on edges.
Top half coming soon.
**Feedback welcome and requested!**
**See below regarding the other access holes**
*EDIT*
Top now uploaded. Cut-away section where it would be opposite the larger chip on the "top" side of the board.
Will create cut-away section for airflow on lower section soon.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
